Pro-boat PRB3600 Bedienungsanleitung

SpecificationsHull Length ... 40 in (1016mm)Beam ... 10.5 in

10Lower the threaded stud into the pre-drilled holes in the top of the hull. Slide the tubing onto the stud from the inside of the hull. Repeat this

11Slide the navigation light into the forward hatch, guiding the wires through the holes in the cabin. Use medium CA to secure the navigation light to

12Make sure the radio is "ON" and the battery is plugged into the speed controller. Test the radio system for proper operation and then care

13If you have any questions concerning the setup or running of your PT-109, please call the Horizon Service Center toll-free at (877) 504-0233.PRB3105

14PRB3602PRB3624PRB3623PRB3610PRB3617PRB3105PRB3608PRB3607PRB3610PRB3606PRB3618PRB3615PRB3603PRB3609PRB3014PRB3609PRB3616PRB3619PRB3610PRB3604PRB3621P

15This product must not be disposed of with other waste. Instead, it is the user’s responsibility to dispose of their waste equipment by handing it ov

16Damage LimitsHORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION OR COMMERCIAL LOSS IN ANY WAY

17Inspection or RepairsIf this Product needs to be inspected or repaired, please call for a Return Merchandise Authorization (RMA). Pack the Product s

18Safety, Precautions, and WarningsAs the user of this product, you are solely responsible for operating it in a manner that does not endanger yoursel

19Operating Notes

22Thank you for purchasing the Pro Boat™ PT-109™ Ready-To-Run boat. Please read these instructions carefully before attempting to operate your boat.Th

11221© 2007, Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, Illinois 61822 (877) 504-0233 www.horizonhobby.comPrinted in Chinawww.ProBoatModels.c

3It is important you read and follow this instruction manual before you run this exciting boat. Failure to read and understand the manual could result

4Before you start running your new PT-109, it is absolutely necessary that you read through all of the operating instructions to prevent unnecessary d

5Remove the transmitter battery cover by sliding the cover from top to bottom.Install eight (8) AA batteries into the transmitter. Pay close attention

6Once the batteries are charged, apply the supplied hook and loop tape to the batteries.Attach the remaining hook and loop to the hull as shown.Instal

7Check to make sure the propellers are free from any objects. The first time you turn on your PT-109 the motors may start, and any objects near the

88Checking the Steering OperationWith your PT-109 and transmitter on, move the steering stick to the right to make the rudders move to the right to in

9Use a #1 Phillips screwdriver to remove the screw from the rear cover.Carefully lift the rear cover at the rear. A tab holds the cover at the front,