Pro Boat Stiletto Spezifikationen

SpecificationsLength ...30.125 in (765mm)Overall Length ...

10Checking the Steering SetscrewsIt may be necessary to tighten the setscrews attaching the steering arm and shaft to the motor mount if your boat is

11Warranty PeriodExclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from defects i

12Questions, Assistance, and RepairsYour local hobby store and/or place of purchase cannot provide warranty support or repair. Once assembly, setup or

13Non-Warranty RepairsShould your repair not be covered by warranty the repair will be completed and payment will be required without notification or

14Declaration of Conformity(in accordance with ISO/IEC 17050-1)No. HH2010052002Product(s): Pro Boat Stiletto BindNDriveItem Number(s): PRB4000BD

15Go to ProBoatModels.com to see photos of the replacement parts listed under Stiletto. If you have any questions concerning the setup or running of y

®18117 v2Printed 05/2010© 2010 Horizon Hobby, Inc.horizonhobby.com www.proboatmodels.com

22Notice ...2Meaning of Special Language

3It is important that you read and follow this instruction manual, along with the radio system manual before you run this exciting boat. Failure to re

4Required Equipment and AccessoriesTransmitter with batteriesMotor batteries (charged)Hook and loop tape 1. Locate the pieces for the boat stand. Th

5The programming module offers other beneficial adjustments like exponential throttle curves, and timing adjustments. Visit ProBoatModels.com and sear

6 7. Check the operation of the propeller in relationship to the throttle trigger. When the trigger is pulled in, the propeller must rotate counterc

7Use a 3mm hex wrench and 7mm open end wrench to loosen the two bolts that attach the motor to the mount to adjust the trim.Finding the proper trim an

8Lubricating the Flex ShaftLubricating the drive system is vital to the life of the drivetrain. The lubricant also acts as a water seal, keeping water

9 3. Use needle nose pliers to grab the flex shaft, removing it from the lower end. 4. Use a paper towel and rubbing alcohol to clean the flex sha